Rust inhibiting primer for single and two-components paints
OWATROL® C.I.P. is a universal rust binding primer for all paint types. It will not dissolve or break down when high solvenst paints applied to it. Penetrates and stabilises the surface, forming a solid stable layer that other coatings can firmly adhere to. Pigmentation offers increased protection and perfect film-forming qualities. Easy to use, no need for sanding or sandblasting. Use on new or rusted surfaces, interior and exterior.
Where to use: C.I.P. (Corrosion Inhibiting Primer) is recommended for all severe environmental conditions: marine or tropical climates, corrosive fumes, construction equipment and ballast tanks... C.I.P. is especially recommended where a high resistant paint or two-components finish (urethane, epoxy, chlorinated rubber, synthetic, etc.) is to be applied or necessary.
Recommendations before application: Shake or stir paint well before and during use. Do not dilute. Remove all loose and flaking rust, mill scale and old paint back to a sound surface using a wire brush or scraper. It is not necessary to remove all firmly adhered rust. Surfaces exposed to chemicals (salts, acids, alkalis...) should be washed with water or steam cleaned. Severely contaminated surfaces should be cleaned using the appropriate solvent. Before application, ensure surface is clean, dry and free from oil, grease and other surface contaminants.
Recommendations: with C.I.P. sand or shot-blasted surfaces do not require immediate priming; a light rust coating will not affect its performance or the final result.
coverage: 15 m²/l
application temperature: +5°C to +30°C
drying: about 6 h
recoating time: about 72 h