Inflatable Dinghy Set YACHTING 225 + HONDA BF 2.3 / Sand

These SEATEC YACHTING tenders arn't just suitable as tenders for smaller yachts, they are also especially suitable for usage during excursions and fishing trips as well. When packed up, these boats are very compact and they can even fit in to the trunk of a small car.. They can be quickly packed away or inflated. The major strengths of these units are their stability, comfort and safety on the water!

Easy to handle, even with heavy loads and several people on board - these SEATEC boats provide a safe driving experience at all times. Whether powered by a motor or by rowing, the large diameter air chambers, in conjunction with the enhanced cone buoyancy tubes provide adequate buoyancy in all situations.

The material of these vessels is extremely weather-, abrasion-, oil-, salt water-, fading-, UV light- and aging resistant. The hull consists of 5-layer laminate PVC. The base fabric is extra strong (1100 dtex) and is coated on both sides.

Standard equipment:

• Extra wide floor slats
• 3 air chambers for increased safety
• Flush "Halkey Roberts" - valve
• 2 sturdy, collapsible aluminum paddles with plastic sheaths
• 3 towing eyes in the bow area
• 3 carrying handles, two on the stern, one on the bow
• 2 additional carrying ropes on the inside of the stern
• Dual-sided grip cord
• Circumferential baseboard
• Wooden transom with reinforcement for motor mounting
• Bailer in the transom
• Seating board
• Foot pump, carrying bag, repair kit

Technical data:

Colour	sand/white
Bow form	Modern (MX)
Slats	Type A in dark-grey/white
Lifeline	2 rope holders
Seating board	1
Towing eyes/Transport eyes	3 / no
Length	2.25 m
Width	1.34 m
Length (inner)	1.46 m
Width (inner)	0.61 m
Hose-Diameter	35 cm
Air chambers	3 sections
Pack size (L x W x H)	103 x 58 x 28 cm
Empty weight	20.4 kg
Engine weight	13.5 kg
Air pressure	0.25 bar
Max. engine power	2.5 kW / 3.3 hp
Max. engine weight	24 kg
Recommended shaft length	Short shaft
Transom height (cm)	38 cm
Payload	300 kg
Carrying capacity	2.5

GL-certified

Assertive
The engine provides a high degree of performance for small boats. If necessary, the engine can provide a high amount of torque to move even heavier boats. It is easy to operate, easy to clean and requires minimal maintenance. Add this all to Honda's well-known reliability, outstanding fuel efficiency and low emissions as well. This provides you with everything to get started on the water immediately. This lightweight outboard motor is manually tilted, in order to avoid propeller damage in shallow water or on the beach.

Numerous functions
This engine is not just easy to transport, it's also very easy to operate and provides the user with numerous functions.

Turn the throttle and go: A centrifugal clutch allows you to idle without the propeller rotating. If you want to drive ahead, turn the throttle, which activates the clutch and turns the propeller. This is similar to an automatic transmission.

Further on: For a small boat, it is important to remain agile and able to quickly change direction. The small BF 2.3 can pivot quickly, making it suitable for fast direction changes without switching. Turn the engine by 180 °, and the boat is in reverse. For this reason, you are able to maneuver precisely in a narrow harbor.

Pay attention to your propeller: After securely attaching it to the boat, you will notice that the engine is very lightweight and easy to lift out of the water. This will greatly reduce the risk of propeller damage caused by stones or embankments. When you can safely drive forward again, simply lock it back into place.

Easy to transport: The BF2.3 is incredibly light and easy to transport. Weighing less than 30 pounds, it's the ideal engine for dinghys, car-toppers and other types of small boats.

Compact design
The stunning finish of Honda's Aquamarine Silver can be seen and admired from afar. Even after long periods of usage, this engine looks fantastic. Its compact design extends to its transmission housing as well. It is not just its sleek appearance, but also the reduced water resistance, which will save you money.

Hand-throttle tiller
The ergonomic hand-throttle tiller feels soft in the hand and has a clamping device for fixing it into position. This allows the user to be able to relax and focus on steering.

4Front-Protection
Fights the elements A patented, "Double Sealed" multi-layered paint process, sacrificial anodes, stainless steel technology, and waterproof connectors enhance corrosion protection.

Power in harmony with nature
For a worry-free day on the water, one must maintain a clear conscience. There is no excuse for the pollution of our oceans and waterways. Soichiro Honda had the simple idea to make outboard motors cleaner, quieter and gentler on aquatic organisms.

Technical data:

• Motor OHV - 1 cylinder
• Valves: 2 Cubic capacity: 57 cm³
• Bore: 45 x 36 mm
• Max. RPM: 5,000-6,000 RPM
• Power: 1.7 kW / 2.3 HP
• Cooling: Fan cooling
• Fuel supply: 1 carburator
• Ignition: Transistor magnet
• Transmission: 2.42
• Trim- und Tilt-Setting: Manual in 4 levels
• Length: 410 mm
• Width: 280 mm
• Height: 945 mm
• Transom height: 480 mm
• Empty weight: 13.5 kg