Detalles del producto
The MiniPlex-Lite is not a stand-alone unit however, it is dedicated to be used with a computer.
The MiniPlex-Lite will operate with any navigation software package through the virtual COM port created by the driver. It provides three galvanically isolated NMEA inputs to connect your GPS and other devices like a speed log, wind meter or an AIS receiver.
A unique feature of the MiniPlex-Lite is the auto-sensing NMEA input on channel 3. This input will automatically detect the high speed data from a connected AIS receiver, which runs at 38400 bps as opposed to standard NMEA equipment which runs at 4800 bps (Bits Per Second).
The combination of the MiniPlex-Lite and it's virtual COM port driver is a dedicated NMEA solution, as opposed to a generic Serial <-> USB converter. It offers galvanic isolation to be fully compliant with the NMEA specification and it does not exhibit the well known problems of generic converters like the infamous 'crazy mouse' problem or sudden drop-outs in the NMEA data stream.
Any attempt of Windows to detect Plug & Play devices on our virtual COM port is blocked, resulting in a real trouble-free Plug & Play solution. Just plug in the USB cable, load the driver disk, a few clicks and you're up and running!
The MiniPlex-Lite is completely transparent to NMEA data. Incoming data is simply stored and forwarded as complete NMEA sentences to the computer.
Any data sent by the computer, like steering information for an autopilot, is output on the dedicated NMEA output.
The multiplexer does not send any NMEA data from it's own inputs to it's output! The navigation software is responsible for forwarding selected NMEA data from the inputs to the outputs.
The communication speed to the computer is much higher than the standard NMEA speed, thus there is no possibility of overflow and missing NMEA sentences from the instruments to the computer.
To prevent any overflow to occur when steering data or waypoints are sent from the high speed computer interface to the NMEA output, a flow control is implemented to momentarily stop the computer from sending data when the internal buffer is full. To enable this feature, Hardware Flow Control must be enabled in the communication parameters section of your navigation software.
|Power supply||Powered by USB-Port|
|Inputs||3 x NMEA-0183 / RS-422|
|Outputs||1 x NMEA-0183 / RS-422|
|PC interfaces||USB-Port, drivers for virtual COM-Port|
|Puffer||Input 1,2 and USB-Port: 128 characters, input 3: 256 characters|
|NMEA input speed||4800 bps (4800/9600/19200/38400 on input 3)|
|NMEA output speed||4800 bps|
|USB port speed||57600 bps|
|Dimensions||97 x 97 x 28 mm|
Clientes preguntan a clientes
Su pregunta será automáticamente enviada a otros clientes de SVB y publicada en la página del producto. Por favor no realice preguntas que sólo el equipo de SVB puede responder, como el estado de un pedido o la disponibilidad de un producto. Para preguntas que se refieren a un pedido, por favor contacte a nuestro equipo SVB por email email@example.com o por teléfono al: 960 13 06 40 .