Perfil de capitán SVB de Jesper B.
Este perfil está configurado como privado.
Jesper B. hizó estas preguntas
1
Una pregunta sobre:
DYNA ONE - de alta calidad
Jesper B.
el 13 oct 2018
Hi i need the right rope for my Solent stay. Is this the right and will it Hold Propperly my mast winch and clutch?
I’ll use bronze hank on jib
Respuestas:
Heide G. ha respondido
el 15 oct 2018
Dear Jesper, many thanks for your question about an inner Forestay (Solent stay). DynaOne HS MAX (the zero creep variation) will be an option, but this rope will not work in clutches. In clutches, you need a cover for grip. In that case, we would recommend MegaTwin Vectran as inner forestay.
Jesper B. ha respondido
el 15 oct 2018
Thanks.. I would like the dynaone hs max, but can’t find it?
And the mega twin Vectran, is it the Gleistein mega twin Dyneema?
2
Una pregunta sobre:
Monitor de batería Clipper BM-1
Jesper B.
el 17 oct 2018
Can I extend the wiring? It’s 5 meters and need a few extra meter.
If yes: witch size of cable and will it defect the monitor?
Respuesta:
Try W. ha respondido
el 29 oct 2018
Hi Jesper, I would like to answer your question with "maybe" because I've never tried to prolong the harness but I imagine that it would be possible. There is only low current on the wires and for prolonging the harness I would take 1 or 1,5 mm² cable cross section. But first let's have a look on how shunt and display are working: Current flowing through the shunt creates a very small voltage drop there, which is proportional to the current height. This very small voltage is led via 2 wires to the display and there it is used for current measurement. If these two wires would be very long, there would be two risks. 1. A voltage drop but with 1 or 1,5 mm² wires that shouldn't be a problem. 2: Interference signals could be induced into the long measuring wires and lead to false display values. Some manufacturers minimize the risk of interfering signals by recommending the use of twisted pair wires. In the wiring diagram you will see at the shunt three: yellow, white and black. The black one is MINUS for the display, yellow and white are the two measuring wires. read the manual careful! There is a note which says: Black and white wires may only be combined at the battery-connection-side of the shunt and nowhere else. My advice: keep distance between the measuring wires and other cables or electrical stuff like powerful motors, pumps, etc..
I'm looking forward for your success report. Good Luck!
3
Una pregunta sobre:
Soporte protector del ventilador
Jesper B.
el 23 jul 2022
Will This fit the large plastimo dorade vent?
item Nr.10324
Is is wide enough to turn the dorade all the way around?
Respuesta:
Sven W. ha respondido
el 7 mar 2023
Dear Jesper, we have checked the Dimensions for you. Because the Dimensions of the artikel -#10324#- are bigger than this article, it won´t work. Yours SVB-team.